Sewing the opening used for turning a bag or other accessory right side out isn't difficult, but it sure can be ugly and obvious if not done well!
Sometimes the opening is on the inside of a bag and it's ok if it looks a bit messy, but in many of my patterns--especially for small things--you need to turn the project out right on the front.
There's just no way around it, so you might as well learn how to do this beautifully!
If you follow the instructions below you'll have a nice crease to follow when it is time to sew it up and close the opening.
1. Back stitch where your opening will begin.
2. Then lengthen your stitch (makes it easier to remove the stitches later) and sew the length of your opening.
3. At the end, back stitch again.
4. Now warm up your iron and press the seam open flat.
5. Using your seam ripper (or scissors with fine tips) remove the long stitches between the back stitching at both ends of the opening area.
Viola! You now have a nice crease to follow when slip stitching your opening closed. Even if it isn't perfectly pressed you should still be able to see the faint stitch line left from the removed stitches, which you can then use as your guide.
6. Thread your needle and tie a knot in the end. Insert your needle from the underside of the crease coming out right in the crease line. I start in the middle of the opening. Pull the thread through so the knot is resting on the back side of the crease and out of sight.
7. Directly on the other side of your seam, insert the needle and gently but firmly pull the fabric together. Slide the needle through the underside of the casing created by the crease and come up out of the fabric about 1/4" from the insertion point.
8. Insert the needle again directly across from where you just came up out of the fabric. Slip the needle through the casing again another 1/4" or so and come up. Repeat this the length of the opening.
If you started in the middle you will need to turn at the end and go back to close the other side. I usually go back and forth across the opening area a few times. The first time I make just a few stitches that are widely spaced apart. Then I turn around and come back and sew more stitches in between the existing stitches. It easier to get a nice even look doing it this way. You can use the second--or even third--set of stitches to fine tune and smooth out any parts that might get a little bumpy.
9. Once the opening is completely closed, tie off on one of the existing stitches by coming out of the fabric right next to one of the stitches and then inserting your needle under the stitch. This will leave you with a loop of thread you can pass your needle through to create a knot.
10. Once the knot is in place insert your needle into the fabric right next to the knot and slip the needle through the casing about 1/4" -1/2" and then come out. Pull the thread firmly and the knot will be pulled down into the crease making it less visible. Snip your thread and you're done.
Save
Save
Save
